Strong Particulate Filtration: Navistar MaxxForce DT, 9 & 10 DPF (2008–2010)
What is it?
The Navistar MaxxForce DT / 9 / 10 Diesel Particulate Filter (DPF) for 2008–2010 captures soot and fine particles from your engine’s exhaust stream. It’s a key component for managing emissions and ensuring your system stays clear of blockages.
Why choose this DPF?
Engineered for MaxxForce DT, 9, and 10 engines within the 2008–2010 timeframe, this DPF balances filtration effectiveness with acceptable backpressure. Choosing the right filter helps you avoid clog buildup, forced regenerations, or error codes that often result from using mismatched or low-quality units.
Key Benefits
✅ Matched for Navistar MaxxForce DT, 9, 10 engines (2008–2010)
✅ Captures soot and particulates to maintain flow stability
✅ Helps prevent derates, warning codes, and system wear
✅ Built to resist heat and long service conditions
✅ Direct-fit replacement simplifies installation and ensures proper alignment
Applications
This DPF is intended for trucks, machinery, and equipment powered by Navistar MaxxForce DT, 9, or 10 engines built between 2008 and 2010. It supports emission control systems by capturing harmful particulates before downstream stages.
Installation Notes
Always begin work when the engine and exhaust are fully cooled. Remove the old DPF and inspect adjoining piping, sensors, and seals for wear or damage. Fit the new filter with fresh gaskets, torque mounting hardware to Navistar’s specifications, and confirm good sealing. After installation, clear any fault codes and run a regeneration or drive cycle to verify correct system response.
Final Thoughts
For Navistar MaxxForce engines from 2008–2010, this DPF offers the durability, correct fit, and filtration performance your system needs to maintain proper function and prevent issues down the line.